XJT lite module with my X20,unable to bind.Think I have done everything correctly,selected external module,LR 9,bind,switch on receiver whilst holding F/S button down.Red LED flashes.Switch everything off,then back on.Red LED still flashing,binding has not taken place. HELP Please
looks like your doing everything as you should, did the l9r bind ok to what you used before?
just a suggestion try the binding with say about 2 foot distance between the radio and rx just in case its swamping it.
also try a d8 receiver if you have one just to prove the module isnt at fault.
@richbago The receiver worked OK with my Horus running on an earlier version of ACCST.I think that the XJT Lite module will only accept later versions of ACCST. I dont want to go through the whole process of updating my Horus plus all my receivers.I was hoping I could use Archer receivers on my X20 plus my existing L9R. I will try again.
PS the diode at the rear of the module goes to solid red when in binding mode,I think this is correct.
Thanks for quick reply Richard,one of my fellow club members owes you a drink !!
oh that maybe the issue, when the xjt is in binding it should have green solid and red flashing
It is solid green,red flashing .I have also tried it about 2 metres away from each other.Still no go.
put the receiver back on my Horus,works OK