Setting Up TD R10 to Work with Smart Port Sensors
After getting a TD R10 to register to the tx it would not work. Eventually I found that the ISRM firmware needed updating. So now all well and good.
But I find the S Port vario isn't recognised. I thought that the port (Molex?) on the end would be configured for S Port sensors but reading through the instructions it becomes apparent that channel 1-10 outputs can be configured and S Port is an option. Just wondering if I am correct?
It also seems that a new protocol for sensors has been introduced, FBUS. Will a S Port sensor work with FBUS or does this need to be one of the new Advance sensors?
Needs to be set to sport.
I have managed to get it to work by setting channel 10 output to S Port the downside of this is that I have now lost a channel, at least I only need 8 on this model.