A self-help group for anyone having problems or indeed anybody that can help with FrSKY products.
Greeting from Australia. Fine sunny and warm here! Have just purchased an X9s. All good except for throttle range adjustment.
What I know - motor is an EFlyte 25 and the ESC a HobbyKing 60A. I can get the motor to run by stick down, trim fully down thenraising the stick to about 50%. Anything else when calibrating the thro's just produces a beep -- beep continuously. Tried to re-calibrate the ESC but won't do even the first move.(Stick up) Just plays a few notes then the beep returns. All the other functions (elev,rud, ail,) work as they should. The Tx has the Access protocol installed
The Tx throttle monitors show full travel and the range settings on the graphs are set at 100% both ways.
This is the second model to be installed, the first was my test hack and it all functions are normal with every thing working as it should.
My only hope is someone in the UK can give me some help, local agents have little experience of this Tx and cannot offer much help
Thanks and regards - Billie
Sounds more like an ESC problem than the Tx.
G'day Barry - fitted with a Turnigy Plush 60A ESC. What appears to happen on this particular model/ESC the low Throttle range Starts at about 50%, too high for a low position to get any reading.
E P.
Billie, Email me
modelgliding@aol.com
BC
Problem sorted, the Throttle Sub Trim was set to = rather than the Triangle.
